Taipei Medical University Institutional Repository:Item 987654321/4264
English  |  正體中文  |  简体中文  |  全文笔数/总笔数 : 45073/58249 (77%)
造访人次 : 2389644      在线人数 : 144
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜寻范围 查询小技巧:
  • 您可在西文检索词汇前后加上"双引号",以获取较精准的检索结果
  • 若欲以作者姓名搜寻,建议至进阶搜寻限定作者字段,可获得较完整数据
  • 进阶搜寻


    jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://libir.tmu.edu.tw/handle/987654321/4264


    题名: 牙齒接受鑄釘治療後預防失敗的性質探討---利用動態力分析黏彈性有限元素模型
    Investigation for preventing failure of the teeth with post and core--- analysis of a viscoelastic finite element model subjected to dynamic forces
    作者: 張凱榮
    Kai Jung Chang
    贡献者: 牙醫學系碩博士班
    关键词: 根管治療
    動態力
    黏彈性質
    阻尼比
    ndodontic treatment
    dynamic force
    viscous property
    damping ratio
    日期: 2008
    上传时间: 2009-08-28 12:09:47 (UTC+8)
    摘要: 在過去的研究中顯現,根管治療後接受鑄釘治療的牙齒比較容易發生斷裂,一般認為這是因為可能由於治療過程對牙齒破壞導致牙齒強度降低,但牙齒本身為一黏彈性材料,除了剛性物質外,還有黏滯性物質,如牙髓、牙周韌帶等,因此黏彈性質所造成的影響也應考慮。在根管治療與鑄釘治療後可能會使牙齒黏滯性降低,使得傳導到牙齒內部的應力較高,容易產生斷裂,在本實驗中,利用模態測試測量五顆上顎第一小臼齒未修形前、根管清創後利用暫時填補材料填補、根管封填後利用暫時性填補材料填補、根管治療後利用光聚性樹脂填補、鑄釘與牙冠治療等不同療程中,牙齒阻尼比的改變,結果顯示當根管清創後,牙齒的阻尼比從14.42±2.17%下降至8.50±0.53% (p<0.05)、根管封填且咬合面利用樹脂封填後牙齒的阻尼比從8.50±0.53%上升至13.41±1.92% (p<0.05)、施予牙冠鑄釘治療後牙齒阻尼比再從13.41±1.92下降至7.89±1.70% (p<0.05)。此外,本研究建立一個上顎第一小臼齒的二維有限元素模型,模型經收斂分析與可信度確認後,模擬動態咬合力300牛頓作用在咬窩與顎側咬頭上,並分析不同治療步驟中牙齒內部應力的改變。實驗結果發現,動態力量作用下牙齒的黏滯性會改變應力傳遞時間與最大應力值,而在考慮阻尼比與忽略阻尼比的比較中發現,未修形前的牙齒所造成最大應力下降比率較其他治療步驟大,而且頰側最大應力下降比率大於顎側。因此,利用動態力可以更精確模擬口腔內牙齒受力後的狀態,而在分析不同材料對牙齒最大抗斷裂力的影響時,材料的黏滯性質也須在考量中,以達到更精確的結果。

    In the past researches, it was found that there exists a high failure rate of a endodontic teeth subjected to a traumatic load. Traditionally, this phenomenon was contributed to the reduction of teeth strength due to endodontic treatment. From biomaterials viewpoint, a teeth is a composite with viscoelastic mechanical property. The viscous materials, such as pulp and PDL, must has effect on the stress transduction and distribution of a tooth subjected to a impact force. However, the viscosity properties on the stress responses of an impacted tooth was ignored in biomechanical studies. In our research, we measured the damping ratio of the teeth in the different endodontic treatment stages, such as before preparation, cleaning& shaping, RCF+IRM filling, RCF+ resin filling, and post& crown treatment. The mean values of the tested samples are 14.42±2.17%, 8.50±0.53%, 10.84±1.70%, 13.41±1.92%, and 7.89±1.70% for before preparation group, cleaning& shaping group, RCF+IRM filling group, RCF+resin filling, and post+ crown, respectively. In addition, significant differences were found among the groups (p<0.05). To test the effect of viscosity on the stress distribution of a impacted teeth. 2D finite element models of maxillary 1st premolar with various endodontic treatment were established. Sequently, dynamic force with a maximum amplitude of 300N, was used to applied to the FE model on central fossa and palatal cusp. The results indicated that the transduction and distribution of the stress was changed when altering the damping ratio values of the FE models. The highest decreasing rate in stress was found in the unprepared group when the viscoelastic properties was simulated. In addition, The decreasing rate in of the buccal side is higher than the palatal side in unprepared group. In conclusion, more precise results regarding the stress response of a endodontic tooth subjected to a dynamic loading was obtained. For fracture resistance analysis of teeth viscosity is an important properties for stress distribution and should not be ignored.
    数据类型: thesis
    显示于类别:[牙醫學系] 博碩士論文

    文件中的档案:

    档案 描述 大小格式浏览次数
    tmu-97-M204094011-1.pdf3217KbAdobe PDF464检视/开启


    在TMUIR中所有的数据项都受到原著作权保护.

    TAIR相关文章

    著作權聲明 Copyright Notice
    • 本平台之數位內容為臺北醫學大學所收錄之機構典藏,包含體系內各式學術著作及學術產出。秉持開放取用的精神,提供使用者進行資料檢索、下載與取用,惟仍請適度、合理地於合法範圍內使用本平台之內容,以尊重著作權人之權益。商業上之利用,請先取得著作權人之授權。

      The digital content on this platform is part of the Taipei Medical University Institutional Repository, featuring various academic works and outputs from the institution. It offers free access to academic research and public education for non-commercial use. Please use the content appropriately and within legal boundaries to respect copyright owners' rights. For commercial use, please obtain prior authorization from the copyright owner.

    • 瀏覽或使用本平台,視同使用者已完全接受並瞭解聲明中所有規範、中華民國相關法規、一切國際網路規定及使用慣例,並不得為任何不法目的使用TMUIR。

      By utilising the platform, users are deemed to have fully accepted and understood all the regulations set out in the statement, relevant laws of the Republic of China, all international internet regulations, and usage conventions. Furthermore, users must not use TMUIR for any illegal purposes.

    • 本平台盡力防止侵害著作權人之權益。若發現本平台之數位內容有侵害著作權人權益情事者,煩請權利人通知本平台維護人員([email protected]),將立即採取移除該數位著作等補救措施。

      TMUIR is made to protect the interests of copyright owners. If you believe that any material on the website infringes copyright, please contact our staff([email protected]). We will remove the work from the repository.

    Back to Top
    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 回馈